Dreamscience ST225 3inch Downpipe

3 inch stainless steel Turbo Downpipe for Focus ST225
The Dreamscience downpipe is manufactured from mandrel bent 304 grade aircraft spec stainless steel, this is a direct replacement for the standard pipe. We have it equipped with a threaded boss for the standard oxygen sensor and a bracket for the turbo heat shield. With this downpipe fitted to your car it will allow the turbo to spool up quicker improving throttle response and the torque output of you car. This downpipe is required to reach your power goals. Although you may lose a small amount of low end torque that will be made up higher in the rev range where it is really needed.

FULL Fitting Kit Optional (clamps and bolts)

You can reuse your existing fittings or purchase a new set using the option below before adding to your basket. The set comprises three replacement genuine ford copper downpipe bolts and a genuine ford downpipe gasket.

Shipping info: 

This product is available for shipping inside the UK, Europe and the rest of the world. Shipping times may vary. Extra charges may be incurred if your locations is considered Remote. If this is the case a member of our team will be in touch shortly after you have completed your order.

Fitting info: 

Our Experienced Techs will take good care of your car whilst it is with us. We Follow a strict procedure for each job to ensure a high level of quality is delivered.
This Procedure is below:
– Protect Vehicle Steering wheel with Cover.
– Protect Seats with Cover.
– Pre-work test Drive to fault find before we carry out work.
– Pull in, lift and Strip Vehicle.
– Book out parts and Fit.
– Rebuild
– Road test, check over.
– Final Clean down and Handover.

Technical Assistance. 

For fitting tips and advice please call our technical helpline on +44 1482 224433 to speak with one of our Qualified Technicians or email in on sales@dreamscience.co.uk